Metrologic MLPN 2159 User's Guide download pdf (Page 12)

Figure 5

INSTALLING THE SCANNER TO THE HOST SYSTEM

Integrated USB: Full Speed (MS9524-40 and MS9544-40)

Low Speed HID (MS9524-38 and MS9544-38)

1. Turn off the host system.

2. Connect the 10-pin RJ45 male

connector of the USB cable into the jack

on the Voyager

PDF. You will hear a

‘click’ when the connection is made.

3. Connect the other end of the USB cable

to the host USB port.

4. Turn on the host system.

As a default, the MS9524-38/MS9544-38 leaves the factory with USB

Keyboard Emulation Mode enabled.

For information on configuring the MS9524-38/MS9544-38 for

USB Serial Emulation Mode, please refer to the USB section of the

MetroSelect Single-Line Configuration Guide (MLPN 00-02544).

Plugging the scanner into a port on the host system does not guarantee

that scanned information will be communicated properly to the host

system. Please refer to the MetroSelect Single-Line Configuration Guide

or MetroSet2’s help files for instructions on changing the scanner’s

factory default configuration. The scanner and host system must use the

same communication protocols.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must

meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.

To maintain compliance with standard CSA-C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC

60950-1, the power source should meet applicable performance requirements for a limited

power source.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Metrologic MLPN 2159 User's Guide Page 12